Yardforce classic 500 wide tyre
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wider tyre for more grip and less digging on soft ground
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 50mm wide tyre for the mower that replaces the original 35mm wide tyre. Several patterns have been tested and this one worked best for me.
Wheel fender on the mower chasis needs to be removed and the tyre fits without any modifications to the chasis. There is only one bolt holding the fender and then a little force needs to be used to remove it.
For the wheel, first remove the original rubber tyre. Use a flat head screwdriver to pry it off and then just cut it. Then use the screwdriver to pry off a bit of the tyre and just pull it off. Plastic studs that are left on the wheel need to be cutt off with a knife. Photos are attached.
The new tyre can be pushed over the wheel with a little force. I have not had any problems with it slipping off since there is a groove where the wheel sits in the tyre. Just be sure to really push the edge of the tyre over the wheel completely. Wider edge of the tyre is on the outside. The wheel cap also fits on the wheel.
It was printed in TPU 95A with supports and 100% infill.