Wall Mount for Makita DC18RC Charger

Wall Mount for Makita DC18RC Charger

A three-part wall mount for the Makita DC18RC charger.

Printing

• Print the parts in the orientation provided in the STL files.

• Supports are recommended for the holes.

• The parts in the photos were printed in PETG with 25% infill.

• If you regularly remove and replace the charger, PC or ABS is recommended.

Assembly

• Follow the numbers and arrows in the photo.

• Push the charger into support (1) while gently turning support (2). Move slowly to avoid breaking the printed part.

• Once the charger rests on supports (1) and (2), push it into position (3).

• The rubber feet may require you to gently pull the charger outward while fitting it into place.

Disclaimer

This is an independent 3D printable accessory and is not affiliated with, endorsed by, or sponsored by Makita.

Note

The same version of this model is also available on Thingiverse. For documentation, printing instructions, updates, and the changelog, visit: https://www.thingiverse.com/thing:7416156

License

Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)

You are free to:

• Share — copy and redistribute the model in any medium or format

• Adapt — remix, transform, and build upon the model

• Use commercially

Under the following terms:

• Attribution — You must give appropriate credit to the original author

• ShareAlike — If you modify the model, you must distribute your contributions under the same license

This model is provided as-is, without warranty. Use at your own risk.