Sturdy low-profile din-rail mount for XP Flexpower supply
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses metric hardware instead of printed flexures for sturdy mounting. Low profile so the bottom panel can be installed.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
XP Flexpower X7-3W1P1P5Z power supplies are a convenient multi-voltage option for powering Voron printers from a single supply. Problem is, they are very big and very heavy. I designed this mount to use metric hardware to avoid printed flexures that may creep over time and low-profile enough to allow the electronics-bay bottom cover to be installed. I have these in both my V2 300 and my Trident 250.
Print instructions: Print for maximum strength, i.e. lots of perimeters and high nozzle temperature. Designed for ABS with shrink compensation off. Print in the orientation shown.
BOM:
2x din brackets
4x m4x8 FHCS
2x m3 square nut
2x m3x40 SHCS (longer screws give easier access for securing to din rain)
stabilizers (recommend using one on each side for maximum stability)
2x m4x8 FHCS
2x m5 t-nut for 2020
2x m5x10 BHCS or SHCS