Throttle Linkage Bushings for Onan Generators
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Throttle linkage bushings for multiple Onan generators. Governor and carburetor bushings included.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This is a set of throttle linkage bushings for an Onan RV generator. It was designed for a Marquis Gold 5500 but will likely fit other models as well. Two bushings are included. The slightly larger one is for the governor arm and the smaller one is for the carburetor. These are designed to be a reasonably tight fit and snap into place. The generators get extremely hot, so ASA, Nylon, etc are a must. Fine layer heights should be used to preserve the angles and contours. A pair of these should print in just a couple of minutes.