1 / 3
Battery clip for Chirp plant water moisture monitors — zdjęcie 1
1 / 3

Battery clip for Chirp plant water moisture monitors

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A little clip to take the load off of the solder joints on the Chirp battery holder

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution

Description

I've got a few of the Chirp plant moisture monitors around the place but I've noticed that over time the metal battery clips tend to get forced off of the PCB on one side by the pressure of the battery, especially if using larger sized batteries. Once that happens the battery doesn't make good contact any more and the Chirp fails to sound when the plant is getting dry. To combat this I've made these little clips that slide over the battery and it's holder to take some of the load off of the solder joint

Print settings

  • Print in ASA-CF/ASA-GF since it needs strength and probably UV/moisture resistance

  • Use at least 3 perimeters

  • Use at least 25% infill

  • Print standing upright on the bed as shown

Tagi