Battery clip for Chirp plant water moisture monitors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A little clip to take the load off of the solder joints on the Chirp battery holder
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
Description
I've got a few of the Chirp plant moisture monitors around the place but I've noticed that over time the metal battery clips tend to get forced off of the PCB on one side by the pressure of the battery, especially if using larger sized batteries. Once that happens the battery doesn't make good contact any more and the Chirp fails to sound when the plant is getting dry. To combat this I've made these little clips that slide over the battery and it's holder to take some of the load off of the solder joint
Print settings
Print in ASA-CF/ASA-GF since it needs strength and probably UV/moisture resistance
Use at least 3 perimeters
Use at least 25% infill
Print standing upright on the bed as shown