1 / 4
Frog Coaster Holder + Lilypad Coasters — zdjęcie 1
1 / 4

Frog Coaster Holder + Lilypad Coasters

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of Lilypad and lily Flower coasters with a frog Coaster Holder. ribbit.

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Share Alike

LILYPAD COASTERS + FROG HOLDER!!!

I keep forgetting coasters, so lets make them cute so hopefully I stop forgetting.  

ASSEMBLY INSTRUCTIONS

To make a physical version of the model above, you will need:

1x Coaster holder (brown)

3x Lilypad coasters (green)

1x Lily Flower Coaster (pink)

Each individual part prints in place with no assembly required. If you want, though, you can paint the eyes of the frog; if I did it right it's gaze should follow you around the room...

NOTES

  • I suggest PETG for this model, especially if you want to bring it outside. PLA should do the trick in most cases, though; just make sure to not eat off the coasters unless you make them with food safe filament. 

  • If my measurements are right the the holder should hold 5 of my custom coasters, or a ton of those paper coasters you get at bars. 

  • Designed for a standard 0.2 layer height, but you could get away with anything smaller for these. Bigger may run into issues with wall thickness and supports. 

  • No I don't know why it keeps importing sideways. Please tilt it so it's bottom side down, as that will be the most filament efficient. 

  • However if you want extra strength you can print the coasters at an angle. The typical face-down orientation will be plenty strong for standard use, however, and will also look nicer. 

Tagi