Frog Coaster Holder + Lilypad Coasters
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A set of Lilypad and lily Flower coasters with a frog Coaster Holder. ribbit.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 13
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Share Alike
LILYPAD COASTERS + FROG HOLDER!!!
I keep forgetting coasters, so lets make them cute so hopefully I stop forgetting.
ASSEMBLY INSTRUCTIONS
To make a physical version of the model above, you will need:
1x Coaster holder (brown)
3x Lilypad coasters (green)
1x Lily Flower Coaster (pink)
Each individual part prints in place with no assembly required. If you want, though, you can paint the eyes of the frog; if I did it right it's gaze should follow you around the room...
NOTES
I suggest PETG for this model, especially if you want to bring it outside. PLA should do the trick in most cases, though; just make sure to not eat off the coasters unless you make them with food safe filament.
If my measurements are right the the holder should hold 5 of my custom coasters, or a ton of those paper coasters you get at bars.
Designed for a standard 0.2 layer height, but you could get away with anything smaller for these. Bigger may run into issues with wall thickness and supports.
No I don't know why it keeps importing sideways. Please tilt it so it's bottom side down, as that will be the most filament efficient.
However if you want extra strength you can print the coasters at an angle. The typical face-down orientation will be plenty strong for standard use, however, and will also look nicer.