GPGF - X1C Hotend Gridfinity Organizers

• Continued to procrastinate by organizing my printer accessories.

• Made some 1x1 Gridfinity caddies that hold X1C hotends

• The cables and connectors get dropped in first, and then they're tucked out of the way - see the cross section screenshot if you're curious.

You can install up to (4) 6 mm x 2 mm disc magnets in the bottom of each caddy if you want that sweet sweet magnetic Gridfinity goodness.

Hope these work for you! The X1C is still great!

Update 261005:

• My R03 bins didn't leave enough Z clearance for my arbitrarily sized drawers that I have underneath my printers.

• R05 is the same module size (1X1Y6Z) but has a deeper pocket for the hotends so that they fit in my drawers.

• Use R03 if you want the size on the hotend to be visible when the hotend is stored.

• Use R05 if you want a lower center of gravity and a lower overall height when in use.

• I also noticed that the part names were incorrectly indicating a 5u height; I've changed all the file names to be accurate to the fact that the base module is a 6u height.

• I've attached a multicolor 3MF for the R05 3D.