Toddler Deterrent - IKEA BRIMNES TV Unit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Single Piece (per door) blocker for an IKEA BRIMNES TV Unit. No screws, no adhesive, no damage, no supports.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
I had a very curious toddler running around the house and wanted a way to lock down an IKEA cabinetswith games and puzzles. Small puzzle pieces and toddlers don't go well together. I ended up creating this bracket that just clips onto the base rail of the BRIMNES TV Stand by IKEA.
Printing
I opted to use black PETG so it would be less brittle than PLA and also slightly stronger. I'd recommend opting for more walls (3-4) if you really want it to be strong. It can easily flex out of the way at its ultimate length.
Installation
You can either take the door out or just look underneath. Above all else, please use common sense. If you assembled the TV stand yourself, I assume you don't need instructions, but here they are:
Option 1: Removing the door
Take the door off by sliding it out and lifting the back at the end of travel
Slide the clip in from top to bottom
Reinsert door, being careful to not hit the clip
Option 2: Keeping door in place
Note: there is a support rail in the middle of the door. Do not try to install the hook in the middle - install it about 1/2 to the middle, then slide it when in place
1/4 of the length of the drawer (halfway to the middle) from either side, feed in the hook in the same orientation it is printed
Align the square opening and the base bracket, rotate 90 degrees so it is "clipped in"
Push all the way down (if you do not push all the way down, it will interfere with the door supports)
Slide to the middle