Kazoo giant - huge - large - double
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You need a pointlessly over-sized vibrato instrument? Here you go.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 126
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This project is a giant kazoo, designed to inject a bit of drama and fun into a ukulele band performance or wherever else a pointlessly over-sized vibrato instrument might add value. It has two membrane clamps to increase volume and vibrato.
For the vibration membrane I used some plastic bag. Just adjust the clamps until the membranes can vibrate freely (looser is better than tighter). Blow in the large end (with the arrow) making a humming noise.
Print notes:
This bg file prints in a single colour PETG with supports also in PETG (on a Mk4) on it’s side on the diagonal (it is too long to print vertically on a mk4). The print file prints on its side to increase radial strength. This costs a bit of support. The bg file is coded for snug supports.
Also supplied is a 3mf prints (as shown) in two PETG colours and with PLA contra support at the interface layer. (on a H2D). It will produce high waste and a waste purge tower. A STL is also provided so you can print however you prefer.
If your printer allows, the model lends itself to printing in the Z plane with more ease and much reduced support, but with reduced longitudinal strength. The clamps print top face down, no support required.