Kazoo giant - huge - large - double
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€9.80 – €11.97 net (excluding VAT)
For file: Giant_Kazoo_V3_0.4n_0.15mm_PETG_MK4IS_12h11m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €10.88 excluding VAT (range midpoint).
- Weight reported by the author
- 117 g
- Print time reported by the author
- 12.18 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
You need a pointlessly over-sized vibrato instrument? Here you go.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 14
- Makes
- 0
- Views
- 126
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This project is a giant kazoo, designed to inject a bit of drama and fun into a ukulele band performance or wherever else a pointlessly over-sized vibrato instrument might add value. It has two membrane clamps to increase volume and vibrato.
For the vibration membrane I used some plastic bag. Just adjust the clamps until the membranes can vibrate freely (looser is better than tighter). Blow in the large end (with the arrow) making a humming noise.
Print notes:
This bg file prints in a single colour PETG with supports also in PETG (on a Mk4) on it’s side on the diagonal (it is too long to print vertically on a mk4). The print file prints on its side to increase radial strength. This costs a bit of support. The bg file is coded for snug supports.
Also supplied is a 3mf prints (as shown) in two PETG colours and with PLA contra support at the interface layer. (on a H2D). It will produce high waste and a waste purge tower. A STL is also provided so you can print however you prefer.
If your printer allows, the model lends itself to printing in the Z plane with more ease and much reduced support, but with reduced longitudinal strength. The clamps print top face down, no support required.