Sovol SV06 Plus CRTouch Probe Mount (Volcano Nozzle, Nautilus Fan Compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for the CRTouch on a Sovol SV06 PLUS designed to be used with a volcano nozzle and compatible with horn fan mods
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I got annoyed that I couldn't find a CRTouch probe mount that
Worked with a volcano nozzle
Didn't interfere with fan mods
Had low profile for maximum bed printing space
So I made my own.
I used supports for the side two overhangs, can also use it on the bridge if your cooling is bad.
I recommend printing with a temperature resistant filament like ABS or PETG. I used PETG-CF. Other filaments will likely melt/soften from the bed heat and throw off your z-offset tuning.
Parts Required:
- CRTouch Probe
- This mount
- 4 M3x10mm screws
- 2 M3 Nuts or 2 M3 heat set inserts
Install:
- Print the part
- Install the probe mount to the toolhead with two M3x10mm screws
- You will need to screw the mount to the toolhead first otherwise one of the mounting screws will be
inaccessible.
- Thread two M3x10mm screws through the probe into the probe mount and tighten a nut on each to secure it to the probe mount
- Alternatively, use a soldering iron to press in two heat set inserts to the bottom of the probe mount
holes and secure the probe to it with that
- Update your printer's config file with the following x and y offsets (I use klipper, there is probably an equivalent setting somewhere in Marlin):
[bltouch]
sensor_pin: ^PB1
control_pin: PB0
x_offset: 29.5
y_offset: -21