Sovol SV06 Plus CRTouch Probe Mount (Volcano Nozzle, Nautilus Fan Compatible)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mount for the CRTouch on a Sovol SV06 PLUS designed to be used with a volcano nozzle and compatible with horn fan mods
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 6
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
I got annoyed that I couldn't find a CRTouch probe mount that
Worked with a volcano nozzle
Didn't interfere with fan mods
Had low profile for maximum bed printing space
So I made my own.
I used supports for the side two overhangs, can also use it on the bridge if your cooling is bad.
I recommend printing with a temperature resistant filament like ABS or PETG. I used PETG-CF. Other filaments will likely melt/soften from the bed heat and throw off your z-offset tuning.
Parts Required:
- CRTouch Probe
- This mount
- 4 M3x10mm screws
- 2 M3 Nuts or 2 M3 heat set inserts
Install:
- Print the part
- Install the probe mount to the toolhead with two M3x10mm screws
- You will need to screw the mount to the toolhead first otherwise one of the mounting screws will be
inaccessible.
- Thread two M3x10mm screws through the probe into the probe mount and tighten a nut on each to secure it to the probe mount
- Alternatively, use a soldering iron to press in two heat set inserts to the bottom of the probe mount
holes and secure the probe to it with that
- Update your printer's config file with the following x and y offsets (I use klipper, there is probably an equivalent setting somewhere in Marlin):
[bltouch]
sensor_pin: ^PB1
control_pin: PB0
x_offset: 29.5
y_offset: -21