1 / 3
Door Stop Wedge with Anti-Slip Grooves - No Supports (S / M / L) — zdjęcie 1
1 / 3

Door Stop Wedge with Anti-Slip Grooves - No Supports (S / M / L)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Solid door wedge with V-grooves underneath that grip carpet and laminate. 3 sizes, prints on its side.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

A solid door wedge that actually stays put. Slide the thin nose under the door and the door holds it in place.

  • Anti-slip grooves: 90° V-grooves across the bottom (1 mm deep, 4 mm pitch). Their edges grip carpet, rugs and laminate, so the wedge does not slide out.

  • Tuned angle: 11–14° – steep enough to hold and shallow enough to slide under most doors.

  • Thin nose: only 2.5 mm thick, with a rounded edge, so it slides under low doors.

  • Rounded back: R4 top edge, comfortable to push with your foot.

  • Solid: no cut-outs and no thin parts to snap.

  • 3 sizes: S 80 × 32 mm, 17 mm high (gaps ~5–12 mm); M 100 × 35 mm, 24 mm high (gaps ~8–18 mm); L 120 × 38 mm, 31 mm high (gaps ~12–25 mm).

Print settings

  • Orientation: as supplied (lying on its side), no supports, no brim. Layer lines run along the wedge, so it is strong when kicked.

  • 0.20 mm layer, 2–3 walls, 15% infill (more infill = heavier wedge = better hold).

  • PLA or PETG. For tiled floors a TPU version (or rubber tape on the bottom) grips best.

  • Time on Bambu Lab A1 with PLA at 0.20: S – 37 min / 11.9 g; M – 47 min / 19.6 g; L – 1 h 02 min / 29.6 g.

Designed from scratch by bezbajzlu.

Tagi