Door Stop Wedge with Anti-Slip Grooves - No Supports (S / M / L)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Solid door wedge with V-grooves underneath that grip carpet and laminate. 3 sizes, prints on its side.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
A solid door wedge that actually stays put. Slide the thin nose under the door and the door holds it in place.
Anti-slip grooves: 90° V-grooves across the bottom (1 mm deep, 4 mm pitch). Their edges grip carpet, rugs and laminate, so the wedge does not slide out.
Tuned angle: 11–14° – steep enough to hold and shallow enough to slide under most doors.
Thin nose: only 2.5 mm thick, with a rounded edge, so it slides under low doors.
Rounded back: R4 top edge, comfortable to push with your foot.
Solid: no cut-outs and no thin parts to snap.
3 sizes: S 80 × 32 mm, 17 mm high (gaps ~5–12 mm); M 100 × 35 mm, 24 mm high (gaps ~8–18 mm); L 120 × 38 mm, 31 mm high (gaps ~12–25 mm).
Print settings
Orientation: as supplied (lying on its side), no supports, no brim. Layer lines run along the wedge, so it is strong when kicked.
0.20 mm layer, 2–3 walls, 15% infill (more infill = heavier wedge = better hold).
PLA or PETG. For tiled floors a TPU version (or rubber tape on the bottom) grips best.
Time on Bambu Lab A1 with PLA at 0.20: S – 37 min / 11.9 g; M – 47 min / 19.6 g; L – 1 h 02 min / 29.6 g.
Designed from scratch by bezbajzlu.