Modular Booster Pack Wall Display – Wall Mount & IKEA SKÅDIS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modular display for sealed booster packs, with connectable holders, wall-mount options and an IKEA SKÅDIS adapter.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Display your sealed Pokémon booster packs vertically with this modular holder, adapted from the Modular Toploader Wall Display.
The original modular design is retained, including the connector slots for joining multiple holders together.
Booster pack size
The holder has a nominal internal space of 68 × 123 × 6 mm, designed around modern Western Pokémon booster packs measuring approximately 66 × 120 × 4 mm.
The extra space allows for the packaging foil and sealed edges. Pack dimensions vary between sets. This version is intended for loose sealed packs, without a rigid protective case or cardboard sleeve.
Included files
Booster_Holder_No_Mounting_Holes_V2.stl — holder without wall-mounting holes.
Booster_Holder_With_Mounting_Holes_V2.stl — holder with wall-mounting holes.
Press_Fit_Connector_V2.stl — connector for joining holders together.
SKADIS_Adapter_Booster_V5.stl — matching IKEA SKÅDIS adapter.
SKADIS_Adapter_Booster_V5.step — editable STEP file of the adapter.
Features
Original modular connector slots retained.
Two holder versions: with and without wall-mounting holes.
Vertical booster pack display.
Front retaining lips.
Separate, full-width IKEA SKÅDIS adapter.
Rounded adapter corners.
40 mm SKÅDIS hook spacing.
Assembly
Slide the sealed booster pack into the holder from the top.
Use the included connectors to join multiple booster holders.
For direct wall mounting, use the version with mounting holes and suitable screws.
For IKEA SKÅDIS mounting, fit the matching booster adapter into the upper connector slots and hang it on the pegboard.
Use the booster-specific SKÅDIS adapter included here. The original Toploader adapter is wider and does not match this resized holder.
Validation
The STL meshes were checked for closed geometry. The booster version has not yet been physically print-tested, so print one holder first to check the fit with your packs.
Original design
This model is a booster-sized adaptation of the Modular Toploader Wall Display:
The original Toploader holder files remain unchanged.
AI-assisted design
AI tools assisted with resizing the original geometry, adapting the SKÅDIS adapter and preparing the model presentation.