1 / 3
Enclosure Case for Adafruit SHT40, SHT41, and SHT45 Temperature & Humidity Sensors — zdjęcie 1
1 / 3

Enclosure Case for Adafruit SHT40, SHT41, and SHT45 Temperature & Humidity Sensors

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adafruit SHT40, SHT41, and SHT45 Sensor case

Ocena
0 / 5
Polubienia
3
Pobrania
52
Wydruki
0
Wyświetlenia
164
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Case for Adafruit SHT40, SHT41, and SHT45 Temperature & Humidity Sensors

MODEL REMOVAL NOTICE :
Download while you can will be removing this model at the end of the month !
because no appreciation for the work being shared will not be further improvements or versions.

This model is 100% free and open-source. I don't run a Patreon or ask for money, all I ask in return for the hours spent prototyping is that you hit the ❤ Like button or post a picture of your build. It takes one second, costs nothing, and tells me the design was worth sharing.

I2c Adafruit SHT40, SHT41, and SHT45 Temperature & Humidity Sensors 

Features :

  • fixing point for cable tie to clamp cable for cable relief 

  • Vented slots for vertical or horizontal mounting air flow

  • protects delicate electronics from bumps or debris

  • mounting holes for screws or can be fixed with double sided tape or silicone

  • Press fit angled vented lid

Printing :

No supports needed
2-3 parameters
15% infill
 
Printed in ASA-CF for heat resistance 

Building :
You will need one of the SHT4x I2C Sensor Modules found here:

SHT45 I2c Precision Temperature Humidity Sensor Module 0.1°C Precision :
https://link.amazon/B02hb8owC

SHT41 I2C Temperature Humidity Sensor Module ±0.2℃ Precision :
https://link.amazon/B0d9eRD96

SHT40 I2C Temperature Humidity Sensor Module ±0.2℃ Precision :
https://link.amazon/B049WdmKe

3 x small plastic screws 
https://link.amazon/B0hY2dglY

Uses 3 of the 4 screw holes for mounting as the cable slips under the board for direct connection to pads or JST connectors.

Screws are tiny the holes in the posts are 1.6-1.8mm the holes in the board are only 2.5mm , plastic screws from a watch or small electronic devices etc is what i used to secure the board to the model, and a small cable tie to secure the cable or you can silicone the cable into the hole.

Happy printing.

Tagi