1 / 3
Terrarium Lid (18x18 in) with Drop-In Panels (Glass / Acrylic / Polycarbonate) — zdjęcie 1
1 / 3

Terrarium Lid (18x18 in) with Drop-In Panels (Glass / Acrylic / Polycarbonate)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

18x18in terrarium lid with recessed seats for 1/8in acrylic, polycarbonate, or glass. Vents customizable in OpenSCAD.

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
28
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution — Noncommercial

Parametric lid for an 18x18 inch terrarium, designed to print in 9 pieces that puzzle-lock together. Fits printers with a 256mm bed or similar.

Printed pieces

  • - 1x center section (holds the 8x8 panel)

  • - 4x side sections (hold the 4x8 panels)

  • - 4x corner vent sections

Panels

  • - Seats are sized for 1/8in sheet with 1/16in clearance

  • - Cut sheets to: 1x 8x8in, 4x 4x8in

  • - Works with acrylic, polycarbonate, or glass

  • - Panels rest on a 0.2in support lip

Vents

  • - Four corner grills, 4x4in each

  • - Patterns: Diagonal (adjustable angle), Horizontal, Vertical, Round

  • - Slot width and spacing are adjustable in the SCAD

QOL Info

  • Two 1/2in cable notches on the back edge (toggle on/off)

  • Frame is 1/4in thick

  • Print all 9 pieces flat, as oriented in the STLs. No supports needed.

  • Don't scale in the slicer. The puzzle joints are toleranced at 100%.

  • Print one corner and one side piece first to test the fit before committing to the full set.

  • Use the same filament and settings for every piece so shrinkage stays consistent.

  • 3+ walls helps the joint tabs survive assembly.

  • 15-20% infill is plenty.

  • PETG recommended.

Tagi