1 / 3
Terrarium Lid (18x18 in) with Drop-In Panels (Glass / Acrylic / Polycarbonate) — image 1
1 / 3

Terrarium Lid (18x18 in) with Drop-In Panels (Glass / Acrylic / Polycarbonate)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

18x18in terrarium lid with recessed seats for 1/8in acrylic, polycarbonate, or glass. Vents customizable in OpenSCAD.

Rating
0 / 5
Likes
1
Downloads
2
Makes
0
Views
32
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial

Parametric lid for an 18x18 inch terrarium, designed to print in 9 pieces that puzzle-lock together. Fits printers with a 256mm bed or similar.

Printed pieces

  • - 1x center section (holds the 8x8 panel)

  • - 4x side sections (hold the 4x8 panels)

  • - 4x corner vent sections

Panels

  • - Seats are sized for 1/8in sheet with 1/16in clearance

  • - Cut sheets to: 1x 8x8in, 4x 4x8in

  • - Works with acrylic, polycarbonate, or glass

  • - Panels rest on a 0.2in support lip

Vents

  • - Four corner grills, 4x4in each

  • - Patterns: Diagonal (adjustable angle), Horizontal, Vertical, Round

  • - Slot width and spacing are adjustable in the SCAD

QOL Info

  • Two 1/2in cable notches on the back edge (toggle on/off)

  • Frame is 1/4in thick

  • Print all 9 pieces flat, as oriented in the STLs. No supports needed.

  • Don't scale in the slicer. The puzzle joints are toleranced at 100%.

  • Print one corner and one side piece first to test the fit before committing to the full set.

  • Use the same filament and settings for every piece so shrinkage stays consistent.

  • 3+ walls helps the joint tabs survive assembly.

  • 15-20% infill is plenty.

  • PETG recommended.

Tags