Kodak Charmera Lens Adapter Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case uses a simple cam latch to secure the Charmera and contains 17mm threads for attaching mobile phone lenses.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is my fully 3d printed Kodak Charmera case. It uses a cam shaped latch that presses on the side of the Chamera, keeping it locked in place. Additionally, there are 17mm x 0.75 threads to allow typical mobile phone lenses to be attached. Like this fisheye lens (affiliate link).
The design contains 3 total parts: The main body, the latch, and the pin.
There are two options for the pin:
Small piece of filament
Small brad nail approx. 1.65-1.75mm shank diameter
Printing Notes
The printing is fairly standard however I would make sure of a few things:
0.4mm nozzle, 0.16mm layer height
5mm/s speed on overhangs to ensure the threads are adequate.
Supports enabled, but block supports in threaded area
PETG was used for my prints, but others should work well.
You may need to adjust x-y hole compensation for the pin to be a friction fit.
Giveaway
I'm currently running a giveaway (ends October 12th, 2026) for an unopened Charmera, fisheye lens and a clear case (Printed on Form 4) with machined aluminum threads. To enter the giveaway, like this post and follow me on Instagram. This will be removed from the description following the end of the giveaway.
