Presto Screen Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for a Pimoroni Preso screen
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a case for the Pimoroni Presto Kit, which includes a very nice touchscreen and PCB, but doesn’t come with a case. I designed this to be as slim as possible and quick and easy to print, with mounting points on the back so you can attach or display it however you like. The case allows full access to the USB port, the SD card reader, and all the ports and buttons on the back.
Presto has 7 RGB LEDs on the back. If you have multi-material printing and transparent filament, you can print the version with light pipes, which will show the light around the edge of the case. Otherwise, I’ve included a plain-back version for single-material printers.
I’ve also included a desk stand with space for a 2200mAh LiPo cell if you want to power it that way, although the stand works fine without the battery too.
The case is held together with a single screw. You’ll need an M3x6mm screw and a square nut. The nut needs to be inserted into the slot on the bottom of the front section before you insert the screen and PCB.
The front prints face-down without any supports. There is a sacrificial layer over the screw hole, but your screw should push straight through it. The back prints face-up and requires minimal support, just for the two tabs and underneath the screw hole. The stand prints face down and doesn't require supports.
If you’re printing the version with light pipes, I got the best results by setting the infill to 100% for the light pipes only.
There are holes for four captive M3 hex nuts on the back, so you can mount the case to whatever you want. The included stand only uses the bottom two holes, so if you want to use it, you’ll need two additional M3x6mm screws and two hex nuts.
Do not use longer screws here, as you’ll start driving them into the PCB!
If you want to design your own mounting solution, the centres of the mounting holes are 38mm apart horizontally and 40mm apart vertically. Be aware that there is only about 4mm of clearance behind the case, so bear that in mind when designing your mount.