Fruit Fly Trap Lid for TO82 Jars – 19 Funnels, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric 19-funnel lid for TO82 twist-off jars. Prints without supports. Caught 33 fruit flies in the first night.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
# Fruit Fly Trap Lid for TO82 Jars
A fruit fly trap lid with 19 small funnels in a honeycomb pattern. It fits a TO82 twist-off jar, snaps onto the thread lugs, and needs no supports.
## Result
- First hour: 6 fruit flies caught.
- First night: 33 fruit flies caught (22 in one trap, 11 in the other).
I printed three lids and ran two of them side by side. The numbers come from my kitchen and are not a lab test.
## How it works
Fruit flies fly in through the funnel mouths on top (11 mm diameter) and cannot find their way out through the 3 mm exit hole. Each funnel is 20 mm deep and reaches about 18 mm into the jar.
**Bait:** apple cider vinegar with a drop of dish soap and some water. The soap breaks the surface tension so the flies sink. Overripe fruit works too.
## Print settings (what I used)
- Material: HIPS (yellow). ABS should work with the same temperatures. PLA and PETG are untested.
- Nozzle: 0.6 mm, extrusion width 0.82 mm
- Layer height: 0.32 mm (first layer 0.2 mm)
- Perimeters: 10, no infill needed (the part is all walls)
- Supports: none
- Fan: off for HIPS/ABS
- Temperatures: 242/246 °C nozzle, 110 °C bed
- Print time: about 1.5 h, about 22 g
- Orientation: the STL is already flipped, so the plate faces down. Just load it and slice.
## Fit
The lid is tuned to my jar:
- glass neck 77.3 mm
- 80.3 mm over the thread lugs
- 6 thread starts
- 70 mm inside opening, 60 mm inside height
Jars from other brands can differ by a few tenths of a millimetre. Print the **fit test lid** first. It is the same lid without funnels, so it prints fast and uses little filament. If it is too loose or too tight, change D_THREAD, CLEAR or LUG_Z in the generator and run it again.
## Files
- fruit_fly_trap_lid_TO82.stl – the finished trap lid (19 funnels)
- fit_test_lid_TO82_no_funnels.stl – fit test lid, same rim and lugs
- fruit_fly_trap_lid_TO82_generator.py – Python script that generates both STLs
## Customise it yourself
You need Python 3 and three packages: numpy, scipy and scikit-image (install them once with pip):
pip install numpy scipy scikit-image
Then run the script:
python fruit_fly_trap_lid_TO82_generator.py
All dimensions are at the top of the script (jar diameter, lug size, funnel size and depth, wall thickness, bevels). It runs in a few seconds and writes both STL files into the current folder. No CAD software is needed.