Befestigungswinkel für Schranktürgriff / Cabinet Handle Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ein stabiler Befestigungswinkel, um eigene Griffe (z.B. aus Holz) sicher an Schranktüren zu montieren. / A sturdy bracke
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
### Über das Modell / About the model
[DE]
Dieser Befestigungswinkel wurde entworfen, um individuelle Griffe (wie z.B. Holzleisten) stabil an Schranktüren zu befestigen. Ideal für DIY-Möbelprojekte oder um das Design bestehender Schränke aufzuwerten. Der Winkel wird flach an die Schranktür geschraubt, während der eigentliche Griff auf der abgewinkelten Seite befestigt wird.
[EN]
This bracket was designed to securely mount custom handles (e.g., wooden strips) to cabinet doors. Ideal for DIY furniture projects or upgrading existing cabinets. The bracket is screwed flat to the cabinet door, while the actual handle is attached to the angled side.
---
### Druckeinstellungen / Print Tips
[DE]
Da auf dieses Teil beim Öffnen der Tür Zugkräfte wirken, sollte es stabil gedruckt werden.
* Material: Ich habe es erfolgreich aus PLA gedruckt und es hält super. Für maximale Stabilität und Langlebigkeit wird jedoch PETG oder ABS empfohlen.
* Wandlinien (Perimeter): 4 bis 5 Wandlinien bringen deutlich mehr Stabilität als nur ein hohes Infill.
* Infill: ca. 30-40% (Muster: Gyroid oder Cubic).
* Supports: Ja, Stützstrukturen werden benötigt. "Tree-Supports" (Baumstrukturen - siehe Screenshot) funktionieren hier hervorragend, um die obere Befestigungsfläche abzustützen.
* Ausrichtung: Flache Seite auf dem Druckbett (wie im Slicer-Screenshot gezeigt).
[EN]
Since tensile forces act on this part when opening the door, it should be printed strong.
* Material: I successfully printed this in PLA and it holds up great. However, for maximum strength and durability, PETG or ABS is recommended.
* Perimeters (Walls): 4 to 5 perimeters add much more strength than just increasing the infill.
* Infill: around 30-40% (Gyroid or Cubic pattern).
* Supports: Yes, supports are required. "Tree supports" work perfectly to support the upper mounting surface (see slicer screenshot).
* Orientation: Flat side down on the build plate (as shown in the slicer screenshot).
---
### Benötigtes Material / Required Hardware
* [DE] 4x Holzschrauben für die Befestigung an der Schranktür.
* [DE] 1x passende Schraube für die Befestigung des eigentlichen Griffs am Winkel.
* [EN] 4x wood screws to mount the bracket to the cabinet door.
* [EN] 1x suitable screw to attach the handle to the bracket.