1 / 7
Tool Organizer, 40 % faster to print – topology-optimized remix — zdjęcie 1
1 / 7

Tool Organizer, 40 % faster to print – topology-optimized remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Jirka's tool organizer with optimised walls: same pockets, 25 % less filament, 40 % less print time, finger scallops.

Ocena
0 / 5
Polubienia
10
Pobrania
37
Wydruki
0
Wyświetlenia
241
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

WHAT THIS IS

A remix of Jirka's Tool organizer. Same size, same pockets, same wall thickness, but the walls are opened up where the material does nothing. It prints in 7 hours instead of 11.5 and uses 296 g instead of 393 g on an MK4S at 0.2 mm layers.

HOW THE HOLES WERE CHOSEN

Not by hand. Every wall was run through my own topology-optimisation code as a thin plate, with loads where they occur in use: tools leaning against every section of every wall, a hand pressing down on the top edge, and lifting the full caddy by the back or side wall. The optimiser keeps a beam along the top, pillars to the floor and arches in between, and removes the rest. Each wall was then checked against the solid wall. Dividers keep 64-71 % of the material and 94-100 % of the stiffness against leaning tools; row walls 60-64 % and 86-97 %; the back wall 60 % and 96 % (64 % for lifting the full caddy); the side walls 76 % and 89 % (80 % for lifting). So it is lighter and faster, not flimsy. Calculated, not measured.

PRACTICAL DETAILS

A closed 15 mm sill in every wall: screws and nozzles stay in their pocket. A finger scallop in the front wall of every pocket, like the original's tray. Walls and floor are 2 mm: with 2 perimeters at 0.45 mm the walls print as four solid lines, no infill needed, so the infill setting hardly matters.

PRINTING

Flat on the bed as uploaded, no supports; the arch tops are short bridges and printed clean. 0.2 mm layers, 2 perimeters. PETG or PLA+ both work; PLA+ prints the arches cleaner. Printed in Prusament PLA+ Matt Race Red on an MK4S, 7 h 00 min. Fits the MK4S bed: 220 x 180 mm.

CREDITS AND LICENSE

Remix of "Tool organizer" by Jirka (Public Domain). Thanks for a part that was worth the work. This remix: CC BY 4.0, use it as you like, credit appreciated. Made with my own voxel topology-optimization pipeline (Python, GPU) and Opens CAD.

Tagi