kitesurfing control bar floater mold
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Floater mold for kitesurfing control bar. Print it and use for any liquid rubber.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
3mf file mold model is split in 4 pieces with some pins.
Bar pipe placeholder - is 24.5mm in diameter.
Long pin I would recommend replacing with stainless still rod - otherwise it's supper difficult to pull it out of the cured rubber.
Mast do before using as a mold:
sanding mold, I've used buffing dremmel attachment.
paraffin with hair dryer - to cover whole mold, and polish with tissues once it cools down.
and mold release on top of it, cheap silicon based is fine.
I've used it with Smooth-On plus 30% microballoons to make it lighter and pigment for color.
UPDATE:
Added 3d printable floater body - print with Foam TPU (TPU Air) - use bar-floater-printable-body.stl:
Temperature 240 gets a nice density.
I recommend 6 layers of shell and 15% infill - strong and water proof.
MUST apply glue before Foam TPU - otherwise it will stick to your bad forever
support is pretty difficult to disconnect, but o=random orbital sander 320 grid - help really nicly to cleanup the mess.
the result - you can see on picture, white floater. it's way lighter than molded one.