kitesurfing control bar floater mold
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Floater mold for kitesurfing control bar. Print it and use for any liquid rubber.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
3mf file mold model is split in 4 pieces with some pins.
Bar pipe placeholder - is 24.5mm in diameter.
Long pin I would recommend replacing with stainless still rod - otherwise it's supper difficult to pull it out of the cured rubber.
Mast do before using as a mold:
sanding mold, I've used buffing dremmel attachment.
paraffin with hair dryer - to cover whole mold, and polish with tissues once it cools down.
and mold release on top of it, cheap silicon based is fine.
I've used it with Smooth-On plus 30% microballoons to make it lighter and pigment for color.
UPDATE:
Added 3d printable floater body - print with Foam TPU (TPU Air) - use bar-floater-printable-body.stl:
Temperature 240 gets a nice density.
I recommend 6 layers of shell and 15% infill - strong and water proof.
MUST apply glue before Foam TPU - otherwise it will stick to your bad forever
support is pretty difficult to disconnect, but o=random orbital sander 320 grid - help really nicly to cleanup the mess.
the result - you can see on picture, white floater. it's way lighter than molded one.