Modular Mausoleum | OpenLOCK DnD Graveyard Terrain

A free modular mausoleum for your graveyard, built on the OpenLOCK system so it clips straight to the terrain you already own. 8 STLs make one complete building: a 3x3 floor, walls, a pillared entrance and an overhanging roof. The walls, entrance and pillars each come in two versions, one with wall candles and one without, so you can light the place or leave it cold.

What's in the download:

- Stone Floor, 3" x 3"

- Stone Wall, 1" x 3", with and without candles

- Entrance, 1" x 3" with and without candles

- Stone Pillar, 1" x 1", with and without candles

- Roof, 5" x 5"

The largest piece is the roof at 127mm, so the whole set fits a 180mm bed. Print at 100%, because scaling these will stop the clips fitting.

Lay it out before you print it I build all of my terrain in a free 3D builder I made called Crypt Builder. It runs in your browser, you drag pieces onto a grid, and when you are done it packs everything onto print plates with an assembly guide. This mausoleum is in there, along with a Decrepit Dungeons starter kit, and both are free.

This link opens a finished dungeon room that uses these mausoleum pieces alongside that starter kit, so you can see the mausoleum as part of something larger, pull it apart, and build your own:

www.cryptbuilder.com

Assembly

Pieces join with standard OpenLOCK clips. Lay the floor, clip the walls around it, then set the roof on top.

Licence

Free for personal use. Print as many as you like for your own table.

Please do not sell prints of these.

Designed by Tiles from the Crypt.