1 / 7
One-Handed Tear Paper Towel Holder – Universal & Adjustable — zdjęcie 1
1 / 7

One-Handed Tear Paper Towel Holder – Universal & Adjustable

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fully adjustable universal paper towel holder designed for smooth unwinding and easy one-handed tearing.

Ocena
0 / 5
Polubienia
15
Pobrania
24
Wydruki
0
Wyświetlenia
218
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Share Alike

A universal, fully adjustable paper towel holder engineered for convenience and stability.

Thanks to the fine-tuning mechanism, you can adjust the tension perfectly so that the roll spins smoothly when pulling, yet provides enough friction to allow easy one-handed tearing without unraveling the whole roll.

Key Features & Compatibility

  • One-Handed Operation: Perfect tension adjustment allows you to tear off a sheet with just one hand.

  • Universal Fit:

    • Inner Core Diameter: 31 mm – 60 mm

    • Roll Length / Height: 190 mm – 320 mm

    • Outer Diameter: Unlimited!

  • Easy Adjustment: Quick and precise clamping mechanism to fit various towel brands and sizes.

Recommended Print Settings

  • Material: PETG or PLA (PETG recommended)

  • Layer Height: 0.2 mm

  • Infill: 15–25% (Gyroid or Cubic)

  • Perimeters/Walls: 4-6 (for solid threads and structural stiffness)

  • Supports: Only on part - 02_sleeve and 05-shaft

Additional hardware

  • 2x 8x24 pin (might be printed out)

Assembly Instructions

  1. Base & Shaft: Glue 05_shaft into 01_base (the orientation is determined by the cutout).

  2. Pins: Press the pins into 05_shaft so that they protrude from only one side (the other side should sit flush with 05_shaft).

  3. Nut & Support: Place 06_support_plate onto 03_nut.

  4. Slip Ring: Apply a small amount of grease inside 04_slip_ring and press it on. (Tip: Pressing down against a flat table with 04_slip_ring facing downwards is the easiest way).

  5. Check: Verify that 06_support_plate and 04_slip_ring rotate freely.

06_support_plate is there to prevent the paper towel roll from unraveling itself

How to Use

  1. Mounting: Attach the assembled base and shaft to the underside of your cabinet, shelf, or drawer (transparent double-sided nano tape works great).

  2. Loading Towels: Insert the paper towel roll from below. Slide 02_sleeve over the shaft, aligning the pins with the notch, and twist it clockwise until the pins lock into place. A few threads should remain visible below the roll.

  3. Tension Adjustment: Screw on the nut assembly and fine-tune the tension: it should be tight enough to let you tear off a sheet easily, yet loose enough to unroll smoothly with one hand.

Note: If your paper towel roll has an outer diameter larger than 150 mm, simply replace 06_support_plate with a custom-sized one. Keep the inner diameter at 40.2 mm and the thickness/height at 4 mm, while expanding the outer diameter to fit your roll.

Tagi