1 / 3
ColorMix Spinning Tops: Teach About Color Mixing — zdjęcie 1
1 / 3

ColorMix Spinning Tops: Teach About Color Mixing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nine spinning tops that teach ColorMix: the face is a pie chart of the recipe, the rim is the printed mix. No supports.

Ocena
0 / 5
Polubienia
9
Pobrania
11
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Spin-and-Mix Tops are nine small spinning tops that show how ColorMix works. The flat face of each top is a pie chart of pure filaments in the recipe's ratio. The rim, cone and stem are printed in the matching mixed colour. Spin the top and the pie blurs into a single colour you can compare with the rim.

THE NINE RECIPES

1. Green: Cyan + Yellow 1:1

2. Orange: Magenta + Yellow 1:1

3. Blue: Cyan + Magenta 1:1

4. Coral: Magenta + Yellow 3:1

5. Amber: Magenta + Yellow 1:3

6. Lime: Cyan + Yellow 1:3

7. Pink: Magenta + White 1:3

8. Deep teal: Cyan + Black 1:1

9. Olive grey: Cyan + Magenta + Yellow 1:1:1

WHY IT SUITS COLORMIX

- Spinning mixes colour over time and the printer mixes it over layers. Putting the two side by side shows how close they get.

- The face is flat, where layer mixing does not work, so it uses pure filaments only. The mixed colour is kept to the rim, cone and stem.

- Top 9 mixes Cyan, Magenta and Yellow into an olive grey, which shows why the set includes Black.

PRINTING AND ASSEMBLY

- Bodies print face down, so each pie chart is a clean first layer. Stems print standing up. No supports.

- Each top is a separate object, so you can print one or all nine. The full plate is 136 x 169 mm.

- Push the stem's pin into the hole in the face until the collar seats. The hole is 5.2 mm and the pin tapers from 5.15 to 4.9 mm. Add a drop of glue if it is loose.

- Body: 40 mm diameter, 14.4 mm tall. Stem: 22.6 mm long.

THE FILE

- PrusaSlicer 2.9.6 project for the Original Prusa XL 5T (Input Shaper, 0.4 mm nozzle), 0.15mm SPEED profile

- Nine objects, every body already assigned to its extruder

- 9 virtual extruders with 2-, 3- and 4-layer cycles

- Slots: 1 Cyan, 2 Magenta, 3 Yellow, 4 White, 5 Black. All five are used.

- 0.15 mm layers, 10% gyroid infill.

STATUS

Not test-printed yet, and the stem fit is untested. The images are renders. Colours are the ones PrusaSlicer's mixing model predicts for the ColorMix filaments.

Tagi