Solder Fume Extractor UPDATED - With optional tilt risers - 20mm, 40mm, 60mm

NO HARDWARE REQUIRED. Simply slide in the filter and fan and snap on the lid.

UPDATE: the case and lid have been completely redesigned for a better seal and tighter fit and a fan grill has been added. The gap between the dividers in the air gap chamber has been filled in, as well. It helps rigidity and keeps the air flowing through the fan better.

The lid is a tight fit. Don't be afraid to use a bit of force, it was designed this way. You'll see tiny gaps between the left and right lid rim and the case. That is not a mistake. It allows the lid to snap on tighter than if it was placed therefore creating a better seal.

3-stage filter replacement recommendation from the manufacturer - both the pre-filter and the 2-stage filter are recommended to last 1 to 3 months. It comes with 3 pre-filters. If they start to get gray to black, that's when you want to change it (pre-filter).

I powered it with a simple 4-pin (accepts 3-pin connectors) to standard AC adapter at full speed - no speed control.

I recommend rubber feet to keep it in place.

It won't let me post the links to the items so search for these in Amazon or any online retailer that would care them:

Arctic 12P Pro (3000RPM)
Coolerguys Fan Power Supply 100-240v AC to 12v DC 1A Output 3pin or 4pin PWM Connector AC DC Adapter
MUIN Solder Fume Extractor Filter

Requires supports - I kept the model upright which means supports for the fan grill, I did this to avoid the inevitable burrs on the chamber dividers which cause fitment issues with the fan and filter.