1 / 10
MultiBoard Benchy and Filament Sample Swatch Holder Display — zdjęcie 1
1 / 10

MultiBoard Benchy and Filament Sample Swatch Holder Display

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Benchy and Filament Sample Holder for Multiboard - only 4.15g

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Benefits

  • Easy to print

  • Designed for no supports, no brim

  • Minimal Filament at ~4.15g (V0.2)

  • Tested in both PETG and PLA

  • Easily prints 18x on a Core One build plate (~74g and 3h 19m) with auto arrange in PrusaSlicer

Printing Instructions

Choose Attachment Style

  • Small Thread (

  • Push-Fit + Snap

Default profile - 0.2mm Balanced 0.4mm nozzle
  • 0.2mm layer height

  • 0.45mm Extrusion width

  • 15% infill

  • 2 perimeters

  • no supports

  • no brim

Installation

It is technically "tile-able" in that it can be installed next in line to the previously installed ones even when holding a Benchy and Filament Sample. 

It is designed on a 2x2 MU Spacing

Step 1

Small Threaded

Recommend offsetting the rows by one MU

I find taking off the surrounding Benchys is helpful and .

V0.2 can be overtightened past horizontal but holds very steady when positioned level

Push-Fit (Recommended)

As these are slightly more consistently aligned you can have them either offset or on a square 2x2MU grid. It is still easier to place Benchys on and off if aligned in the offset pattern

you will need to insert your snap then into that press the Push-Fit section into it.

Step 2

Add Filament Sample

Align the filament sample through the guide and clip it into place by firmly pushing in the same direction

Add Benchy

it just sits in it.

Step 3

Admire your new display

Tagi