1 / 2
Gears and pulleys for SG90, MG90s, and 25t servos — zdjęcie 1
1 / 2

Gears and pulleys for SG90, MG90s, and 25t servos

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I promise they will fit

Ocena
3 / 5
Polubienia
125
Pobrania
288
Wydruki
0
Wyświetlenia
1271
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

Servo splines suck - they're a mess of undocumented, almost-compatible manufacturer specific variants that are too finely featured to print anyway. Instead of trying to match any specific spline geometry I've added some slots so the gear horn can flex to fit the spline regardless of your printer settings.

Be warned these will slip at higher torques on full size 25t servos, they're best used with 9g servos or in situations where slip is acceptable.

I've generated parts for the following servo splines:

  • SG90 (apx. 4.8mm)

  • MG90s (apx. 4.8mm)

  • Generic 25t (apx. 6mm)

For each spline I've generated the following parts:

If you need a different part you can model it yourself - I've included a screenshot of the sketch in the photos section.

Drop a make or a donation if this saved you an hour of futzing with spline clearances

Tagi