1 / 4
KICHLY 4 L Cereal Box Dry Box Swatch Card Holder + Glue Jig (same spot on every lid) — zdjęcie 1
1 / 4

KICHLY 4 L Cereal Box Dry Box Swatch Card Holder + Glue Jig (same spot on every lid)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Swatch card holder for KICHLY 4 L cereal box dry boxes, plus a glue jig that puts it in the same spot on every lid.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Swatch card holder for the lid of a KICHLY 4 L cereal box used as a filament dry box, plus a press-on glue jig that puts the holder in the same spot on every lid. Fits the KICHLY 4 L lid with the D-shaped pour opening (116.8 mm across at the clip level).

Unofficial accessory, not made or endorsed by KICHLY.

I keep my filament in 4 L KICHLY cereal boxes lying on their backs on a shelf, lid facing out. I wanted a swatch card on every lid so I can see the colour and settings without opening the box, and I wanted all 22 lids to look the same.

Two parts

  1. Lid holder: a slide-in frame for a 76 x 46 x 1.6 mm swatch card. The card clicks onto a small bump and a finger notch pushes it out. The rails only cover the card edges, so the label stays readable. Glue or double-sided tape it to the lid.

  2. Glue guide: presses onto the lid and puts the holder in the same place every time: centred across the lid, 18 mm from the end. One side has a rigid wall, the other has spring feet, so it grips the lid with no side play. Deep end posts stop it sliding along the lid. The window is a "+" shape, so the holder can go lengthwise or across.

Parts list

  • 1 glue guide (print once, reuse for every lid)

  • 1 lid holder per box

  • 1 swatch card per box, 76 x 46 x 1.6 mm

  • Glue or double-sided tape for the back of each holder

How to use

  1. Press the guide onto the closed lid, end posts against the lid end.

  2. Put glue (or tape) on the back of the holder.

  3. Drop the holder into the window and press for a few seconds.

  4. Lift the guide off. Next lid.

Fit check before you print

The guide grips the lid skirt at 116.8 mm wide (KICHLY 4 L, D-shaped pour opening). If your box is a different brand, measure across the lid at the clip level first. It will not fit a lid that is a few mm narrower (my first try was sized for 111.9 mm and did not go on).

Print settings

  • Lid holder: about 11 min, about 5 g, flat on its back, no supports.

  • Glue guide: about 35 min, about 21 g, flat, no supports.

PLA, 0.2 mm layers, 0.4 mm nozzle. Printed on an Elegoo Centauri Carbon 2. The card slot is sized for PLA+ with 0.3 mm clearance per side.

Tagi