Mooer GWF4 HSW Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple vertical holder for the Mooer GWF4 wireless footswitch (Prime P2 / GTRS). The footswitch drops into a cup stand
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
# Mooer GWF4 Footswitch Holder for HSW (Honeycomb Storage Wall)
A simple vertical holder for the Mooer GWF4 wireless footswitch (Prime P2 / GTRS). The footswitch drops into a cup standing on its short end, switches facing out, so it's off the floor and ready to grab.
Features
- Mounts with 2 direct hex pegs in one column of an HSW panel (no inserts needed)
- U-slot in the front wall clears the lowest footswitch (Ø18 + 0.5 mm gap), so it never gets pressed
- 0.4 mm fit gap per side: snug, no rattle
- Rounded window in the floor for the USB-C cable and to push the pedal out
- 1 mm chamfers on all outer edges
Printing
- Prints as is, standing upright, no supports
- Bottom peg lies on the bed; the top peg has a 45° ramp underneath
- PETG or PLA, 0.2 mm layers, 3–4 perimeters, 20% infill
- About 32 g of filament
Size: 45.8 × 41.3 × 48 mm (incl. pegs)
Fits a footswitch of 40 × 26 mm cross-section. The FreeCAD build script is parametric, so you can change the device size, fit gap or slot.
Designed for the original HSW panel by RostaP. Not test-printed yet. Feedback welcome!