1 / 2
Plant Aeration Stick / Pflanzen-Belüftungsstab (250 mm) — zdjęcie 1
1 / 2

Plant Aeration Stick / Pflanzen-Belüftungsstab (250 mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Hollow, slotted aeration stick for potted plants – brings air to the roots, helps against waterlogging. No supports.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
36
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

EN

A simple aeration stick for potted plants. Push it into the soil next to the plant – the hollow body with its rows of slots lets air reach the root zone and gives excess water a way to escape. Handy for compacted soil and plants that tend to stay wet for too long.

  • Length: 250 mm, diameter: 15 mm

  • Hollow body with ventilation slots, pointed tip for easy insertion

  • Prints standing upright, no supports needed (brim recommended)

  • Designed in Fusion 360

Tip: For long-term use in damp soil, PETG or ASA is more durable than PLA. Pre-poke a hole in very firm soil so the stick doesn't break.

DE

Einfacher Belüftungsstab für Topfpflanzen. Neben der Pflanze in die Erde stecken – der hohle Körper mit den Schlitzreihen lässt Luft an den Wurzelbereich und gibt überschüssigem Wasser einen Weg. Praktisch bei verdichteter Erde und Pflanzen, die gern zu lange nass stehen.

  • Länge 250 mm, Durchmesser 15 mm

  • Hohlkörper mit Lüftungsschlitzen, Spitze zum leichten Einstechen

  • Stehend druckbar, keine Stützen nötig (Brim empfohlen)

  • Konstruiert in Fusion 360

Tipp: Für den Dauereinsatz in feuchter Erde hält PETG oder ASA länger als PLA. Bei sehr fester Erde vorstechen, damit der Stab nicht bricht.

Print settings

  • Printer: FLSun T1 Pro, 0.4 mm nozzle

  • Layer height: 0.2 mm, 2 walls, 15 % infill (crosshatch)

  • Supports: none – Brim: outer, recommended (250 mm tall on a 15 mm footprint)

  • Material: PLA+ (printed with Sunlu PLA+ 2.0); PETG recommended for permanent use

Note: The second image is an AI-generated illustration, not a photo of a print.

Tagi