Tag-Connect TC2030-CLIP ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ring with a hinged cradle for the Tag-Connect TC2030-CLIP board. Prints in place, no supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
A ring for the Tag-Connect TC2030-CLIP retaining board. The clip is glued into a cradle that is hinged to the ring, so it can point forward or fold up. The barrel wells flare at the top to make room for the solder on hand-soldered barrels.
It prints in place, with no supports or assembly:
tc2030-clip-ring.stlis printed with the head folded up, which keeps the barrel wells vertical. This is the recommended file.tc2030-clip-ring-flat.stlis printed with the head lying flat.
Free the hinge after printing by working it back and forth a few times.
The ring has a 19 mm inner diameter; change finger_d in the .scad for another size. The pocket is 1.5 mm deep, sized for the clip board as I measured it. Tag-Connect's drawing gives 0.914 mm, so measure your board and change clip_t if it differs.