Yoopai Filament Storage Box Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hanger designed specifically for Yoopai filament storage boxes.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
General Information
With these hangers you get the same effect of placing boxes upside-down without the inconvenience of actually flipping the boxes.
I produced this hanger to hold Yoopai's 'pro' filament storage boxes (Amazon link) so that I can fit more boxes per shelf (see photo). I cannot verify fitment for other boxes; however, other boxes should fit so long as there is a gentle arc along the sides of the lid's long-flap.
Print Settings
The general settings I used were the default OrcaSlicer settings for 0.2 mm layer height with the following settings changed.
Wall loops: | 3 |
Sparse infill pattern: | Triangles |
I recommend this model to be printed in PETG or another stronger material. I believe PLA will be too brittle and may deform over time.
I printed this model on the FlashForge Creator 5 Pro (see .gif).
Assembly
The hangers can be affixed to the under-side of shelves with three M3 wood screws of appropriate length.
Use an empty box to help space the hangers apart. I hung my hangers so they are about 125 mm from outside edges.