Yoopai Filament Storage Box Hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hanger designed specifically for Yoopai filament storage boxes.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
General Information
With these hangers you get the same effect of placing boxes upside-down without the inconvenience of actually flipping the boxes.
I produced this hanger to hold Yoopai's 'pro' filament storage boxes (Amazon link) so that I can fit more boxes per shelf (see photo). I cannot verify fitment for other boxes; however, other boxes should fit so long as there is a gentle arc along the sides of the lid's long-flap.
Print Settings
The general settings I used were the default OrcaSlicer settings for 0.2 mm layer height with the following settings changed.
Wall loops: | 3 |
Sparse infill pattern: | Triangles |
I recommend this model to be printed in PETG or another stronger material. I believe PLA will be too brittle and may deform over time.
I printed this model on the FlashForge Creator 5 Pro (see .gif).
Assembly
The hangers can be affixed to the under-side of shelves with three M3 wood screws of appropriate length.
Use an empty box to help space the hangers apart. I hung my hangers so they are about 125 mm from outside edges.