Fat Pikachu Iron On Shirt Decal or Patch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Iron on Pikachu for your favorite bags, shirts or any other placement you can wrangle
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
Perfect to print and iron onto a shirt or hoodie
Inspired by the Fat Pikachu the original artwork for Pikachu
This decal is available in 0.2 and 0.4 mm or approximately one layer or two. The first time I attempted to put this decal on using 0.2 I applied too much time ironing and it melted too much.
I recommend starting with the 0.4 mm. As it is a bit more forgiving
Feel free to rearrange the facial features to make your fat pikachu either happy, sad, or derpy.
Download the model and open it in your preferred slicer (I used orca) - Print with best color for decal.
After printing, carefully remove the model from the build plate.
Be gentle when removing as the model is only 1 or 2 layers thick - it can tear easily and has floating pieces which should be removed separately. I recommend arranging using Blue masking tape.
Prepare your ironing area: set up an ironing board and an iron, then preheat the iron
Place the garment on the ironing board, position the printed model on the desired area, and cover it with heat-resistant paper (e.g. baking/parchment paper) or silicone mat
Using the preheated iron, press onto the model through the mat/paper (or move the iron evenly, depending on the size of the model) for 15–20 seconds
Wait a moment, then remove the paper/silicone. The model should separate easily and remain on the garment if it does not, hit it for a little more time and test again.
Run your fingers over the pattern - if it feels rough at any part, cover again and hit it for an additional 5-10 seconds.
(Optional) Turn the T-shirt inside out and iron the area where the model is applied for an additional 5–10 seconds
IMPORTANT Note
Washing these items should only be done with cold water as any more than 100 degrees could start to peel the print from the shirt
If your pattern feels rough, it may need a touch more heat.
Note: This is a fan-made model inspired by Pikachu. Pokémon and its characters are owned by Nintendo, Game Freak, and The Pokémon Company. This is not an official product.