Ineos Grenadier Backup Camera Extension Arm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ineos Grenadier Backup Camera Extension Arm move backup camera left 20cm and back 13cm to improve view
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
A 3D print that moves the camera 20 cm to the left, and 13 cm to the rear. Intended to clear a larger rear tire (I have MT 255/85/17) and a larger rear bumpers, such a s the Cruiser Company rear bumper.
To install
Open the back panel of the large rear door.
Locate the backup camera video cable and unplug.
The backup camera is held in plate with a clip. You can find the 2 clips on the top and release them with a long flat screwdriver. Once the top two are released the camera rotates out.
I installed the camera on the arm with VHB tape for insurance.
This step is difficult as the camera hole in the door is down deep. I used a 25cm needle nose plier to hold the aircraft nuts.
Place the backing bracket down the inside of the door. Place the arm on the outside and place the bottom 2 screws (6mm x 25mm cap head SS)
Using the needle nose pliers, position the backing plate over the screw. Then place the nuts on the screw and tighten.
Next place the upper 2 screws.
Plug in the video connector.
Put everything back together and you are finished.
****. If someone can improve this, that would be great. It is stock and functional, but could use radius corners rather than the sharp corners. ****