Clawd - Claude Code Pixel Mascot, 252 mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flat Clawd pixel mascot with recessed eyes. Print in one color, use a layer color change, or load the included eye parts for multicolor printing.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
Clawd from the Claude Code terminal, turned into a large, flat pixel mascot. The shape follows the default sprite in Claude Code 2.1.161. Pixels are twice as tall as they are wide to reflect terminal character proportions.
Dimensions
- Body: 252 x 157.5 x 4 mm.
- Eye pockets: 3.2 mm deep, with a 0.8 mm floor.
- Two separate eye volumes are supplied in the eyes STL, aligned with the body.
Printing
Print flat, eyes upward, with no supports. Designed around a 0.4 mm nozzle. On a P1P plate, only 2 mm remain at either side: do not add a brim, and check the plate edges, front-left exclusion zone and any prime tower.
- One color: print only the body; the eyes remain deep recesses.
- Layer color change: print only the body, starting in black. Switch to orange on the first layer above 0.8 mm. The eye floors and a narrow strip along the lower edge remain black.
- Flush multicolor eyes: import body and eyes together as one object with two parts, preserving their common coordinates. Assign the eyes to black filament. The eye geometry starts at Z=0.8 mm and rests on the body, so do not arrange or print it independently on the bed.
There is no assembly clearance between the supplied eyes and pockets: the eye parts are intended for multicolor printing, not separately printed press-fit inserts.
Editable source
Change target_width, thickness or pixel_aspect in the SCAD file. Use pixel_aspect=1 for square pixels.
openscad -D 'part="body"' -o clawd_pixel_mascot_252mm_body.stl clawd_pixel_mascot_252mm.scad
openscad -D 'part="eyes"' -o clawd_pixel_mascot_252mm_eyes.stl clawd_pixel_mascot_252mm.scad
part="preview" is a display view, not a production STL.
Verification
A P1P slice was checked on 2026-10-01 with a 0.4 mm nozzle, 0.20mm Standard and PLA Basic: approximately 82 min and 71 g for the body. Body and eyes were also sliced as one object; AMS filament assignment has not been verified. No physical test print is claimed.
Clawd and Claude Code are associated with Anthropic. This is an unofficial decorative 3D adaptation.