Powercon splitter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Build your own Powercon splitter from a 3-way outdoor junction box, with a printed hole template and spacers.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Powercon splitters are expensive. Why buy one when you can make it yourself?
I used a 3-way outdoor junction box for the enclosure: https://www.amazon.com/dp/B01M0TF5ZK
Drilling the holes
I needed a way to drill 24 mm holes in the junction box, so I made the Powercon hole template. The template has a notch so you can line it up the right way.
Hold the template on the junction box and drill the 2 smaller holes.
Bolt the template onto the junction box.
Use a 24 mm Forstner bit to drill the bigger hole. This is the bit I used: https://www.amazon.com/dp/B000P4LLDQ
Wiring
I used 14 AWG silicone wire for all the connections. Cut 2 pieces at 4" and solder them together in the middle, then cover the joint with shrink wrap. Do this for the red, black and green wires.
Spacers
Print 4 copies of the Powercon spacer. The ones in the photos were too short and I did not want to reprint them, so I printed a second spacer. The one in the downloads is the correct height of 17 mm.
Parts
Female Powercon sockets (3 white, 1 blue). This is the one I used: https://www.aliexpress.com/item/32746634194.html
8 x M3 x 30 mm hex socket countersunk bolts
8 x M3 washers
8 x M3 nylon lock nuts
More from Bong 69
LED lighting hardware and our light show work: https://www.bong69.com
Print settings
Material: PETG
4 walls (perimeters)
4 top layers
4 bottom layers
25% infill