Cord Winders - Set of 3 for Earphones, Cables and Chargers (OpenSCAD)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wind earphones and charging cables neatly; slots lock both ends. Three sizes on one plate.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Three cord winders to stop cables turning into a knot in your bag or drawer: a small one for wired earphones, a medium one for phone charging cables and a large one for laptop and power cables.
Each winder is a bone shape: hook one end of the cable into the slot in a round lobe, wind it round the narrow waist, then push the other end into the slot on the opposite lobe so it can't unwind. The hole in the top lobe takes an earbud or a small plug. Lengths: 55, 75 and 100 mm, all 3 mm thick.
Make them fit your cables: open the .scad file in OpenSCAD (free), go to Window > Customizer, and change the lengths (one winder per number), the thickness and the slot width. Make the slots a little narrower than the cable so they grip.
Print settings: PLA, PETG or TPU (TPU winders bend nicely), 0.2 mm layers, no supports. They print flat as shown. On a Bambu Lab H2C the three take about 30 minutes and 14 g. A ready plate (the H2C .3mf) is included.
Designed with AI assistance, checked and sliced by me. License: CC BY-NC-SA 4.0.