Ancillary Steam Frame Apple Vision Pro / Quest 3 Adaptor Strap + Backstrap Cross Ring

(If you find any of my models for sale online (ebay, amazon, etc) it is not me, i do not sell prints; especially not at those insane prices. They are all listed as non-commercial works. I do not have a patreon or kofi or any donation platform. These models are only listed here on printables, for free, for you to print or use a print service like PCBway or JLCPCB, or your friends.)

Use your apple vision pro or quest 3 straps with the steam frame... Also a ring to attach the battery..

Fully designed from scratch and optimized for 3dprinting. 

You will need a t5 screwdriver.

Print flat with supports at least 3 perimeters. Print 2x adapters with one mirrored. 

Installation of adapters:

• Remove the two t5 screws for the default strap (you will use these again later)

• Tilt the default strap out and pull

• Tilt the adapters in and replace the T5 screws

Installation of battery ring:

• Remove the fabric pad on the battery

• Remove the t5 screws for the battery shell

• Remove shell

• Remove the 2 screws holding the default strap arms on

• Screw the replacement ring in

• Reassemble

• 

I used this bar to zip tie to the AVP topstrap.