Chicken Coop Door Handle (Bolts Through the Wire)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-part door handle for a chicken coop. The grips bolt together through the wire. Print in ASA or PCTG for outdoors.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
A door handle I designed for our Producer's Pride Chateau Coop from Tractor Supply (SKU 2015286). The handle is two grips, one on each side of the door. Their square stubs pass through the chicken wire and meet in the middle, and two bolts clamp the grips together. The 12 mm gap between the grips' shoulders leaves room for the wire or the door frame, so the handle should work on most coop doors with standard chicken wire.
Two ways to fasten it
Both use the same grip A. Choose one grip B.
Heat-set inserts: use the heat-set insert version of grip B. Press two M6 heat-set inserts into its 8 mm holes, then bolt grip A to it with M6 × 45 mm bolts. Most M6 inserts take an 8 mm hole, but check yours.
Bolts and locking nuts: use the bolt-and-nut version of grip B. Run M6 × 80 mm (or 1/4" × 3-1/4") bolts through both grips and secure them with washers and locking nuts.
The bolt holes through the grips are 6.6 mm. The back of each grip has flat 12.9 mm seats for the bolt heads, washers and nuts.
Printing
Use ASA or PCTG, since the handle lives outdoors.
Print each grip flat, as oriented in the STLs. No supports or brim needed.
How AI Helped
This is my design; I made it in Tinkercad. An AI assistant replaced the rounded bottom edge with a 45° chamfer so it prints cleanly without supports, and centered the bolt holes on the stubs. It also added bolt holes through grip A and a bolt-and-nut version of grip B, with flat seats on the back for the bolt heads and nuts. It made the renders and helped write this description.