1 / 3
E3D V6 40mm fan mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It has been tested for if it fits around the fins, did not test it if it fits with a hot end holder. Has been designed…
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 377
- Wydruki
- 2
- Wyświetlenia
- 1230
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (31)Powiązane
It has been tested for if it fits around the fins, did not test it if it fits with a hot end holder.
Has been designed to be held with a m3 bolt and nut, but the holes are small enough where you can screw the m3 screw into the plastic without nut. The nut is optional.
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Notes:
The plastic under the tab will droop, but that is only for a layer or 2.
Category: 3D Printer Parts