Bolt & Flat-Bar Safety Cover — v1.0 (release) (for RTT)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bolt & Flat-Bar Safety Cover Slip-on safety shell for a 120 x 29.5 x 5 mm stainless flat bar
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
// Bolt & Flat-Bar Safety Cover — v1.0 (release)
//This was created to save your back from nasty scrapes from the bolt from anything mounted on the bed rack like a roof top tent.
// Slip-on safety shell for a 120 x 29.5 x 5 mm stainless
// flat bar carrying 2x M8x55 bolts with washers + nylock
// nuts. Rounds off all exposed threads and plate corners.
// Push up over the plate from below:
// - 4 side fingers (tapered, 3.5 deg inward lean) grip
// the plate edges under preload.
// - 2 end keepers (vertical, 1.2mm float) block peel and
// detachment under wind/vibration without fighting bar
// bow. Removal: flex both keeper tabs, drop one end,
// rotate off.
//
// Material: PETG, 4 perimeters, ~30% infill. Print as
// modeled (opening up), support-free. Plain TPU is NOT
// suitable for this one-piece design - the fingers need
// rigidity to grip.