Riser foot for Samsung dryer DV90DG6845LKU5 (front leveling extension)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Front foot riser for Samsung DV90DG6845LKU5 dryer. Levels it when the built-in feet can’t be screwed out far enough.
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 1
- Wyświetlenia
- 17
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
The front feet of my Samsung DV90DG6845LKU5 dryer can’t be screwed out far enough to level it, so I designed this simple riser. The adjustable foot sits inside the rim [and is centered by the pin / and the pin goes into the foot – bitte anpassen]. Each riser adds 9 mm of height, and the feet stay fully adjustable for fine leveling.
Print two, one for each front foot.
Dimensions
Base: Ø 41 mm, 9 mm high
Rim: 2 mm wide, 3 mm high (keeps the foot from sliding off)
Center pin: Ø 10 mm, 10 mm high
Total height: 19 mm
Recommended material
TPU 95A. It damps vibrations, gives grip on the floor and won’t creep under load. PETG works too but gives less damping. I don’t recommend PLA, because it deforms under constant load and warmth.
Print settings (Prusa MK4S, 0.4 mm nozzle, TPU 95A)
Layer height: 0.2 mm
Perimeters: 4
Top / bottom solid layers: 5 / 5
Infill: 30 % gyroid
Nozzle: 230 °C first layer, 225 °C other layers
Bed: 60 °C (textured PEI, no glue needed)
Max volumetric speed: 3.5 mm³/s
No supports needed. Print it flat side down, as oriented.
Tips
Dry the TPU before printing if the spool has been open for a while.
Let the part cool completely before removing it from the textured sheet.
After placing the risers, level the dryer with the built-in feet and lock them.