Riser foot for Samsung dryer DV90DG6845LKU5 (front leveling extension)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Front foot riser for Samsung DV90DG6845LKU5 dryer. Levels it when the built-in feet can’t be screwed out far enough.
- Rating
- 5 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 1
- Views
- 17
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
The front feet of my Samsung DV90DG6845LKU5 dryer can’t be screwed out far enough to level it, so I designed this simple riser. The adjustable foot sits inside the rim [and is centered by the pin / and the pin goes into the foot – bitte anpassen]. Each riser adds 9 mm of height, and the feet stay fully adjustable for fine leveling.
Print two, one for each front foot.
Dimensions
Base: Ø 41 mm, 9 mm high
Rim: 2 mm wide, 3 mm high (keeps the foot from sliding off)
Center pin: Ø 10 mm, 10 mm high
Total height: 19 mm
Recommended material
TPU 95A. It damps vibrations, gives grip on the floor and won’t creep under load. PETG works too but gives less damping. I don’t recommend PLA, because it deforms under constant load and warmth.
Print settings (Prusa MK4S, 0.4 mm nozzle, TPU 95A)
Layer height: 0.2 mm
Perimeters: 4
Top / bottom solid layers: 5 / 5
Infill: 30 % gyroid
Nozzle: 230 °C first layer, 225 °C other layers
Bed: 60 °C (textured PEI, no glue needed)
Max volumetric speed: 3.5 mm³/s
No supports needed. Print it flat side down, as oriented.
Tips
Dry the TPU before printing if the spool has been open for a while.
Let the part cool completely before removing it from the textured sheet.
After placing the risers, level the dryer with the built-in feet and lock them.